In this short Q&A podcast episode, Bryan answers a question about drain traps and static pressure. This question was sent by Stephen with The Comfort Squad when he noticed an uptick in nuisance calls on retrofit systems that kept having their secondary drain pans filled. In negatively pressurized systems (i.e., straight-cool or heat pump units, not gas furnaces), air can pull water back into the drain line. The evaporator coil is under negative pressure because the blower is on top of the evaporator coil. The rule of thumb for trap depth is that it should be greater than or equal to twice the return static pressure (which is why a 1" deep trap is typical for systems with 0.5" return static pressure). However, return static can have some variation, and it's also not a great idea to use the TESP for this measurement because the return static could be greater than the supply. It makes most sense to account for the highest possible return static you will see. 1" is only sufficient if 0.5" return static pressure is the most you will see, so bigger is usually better in all cases. If you can install a 2" or 3" trap, you'll typically have your bases covered without having an excessive trap. We also wrote a tech tip about this topic: https://hvacrschool.com/drain-trap-depth-and-negative-pressure/ Have a question that you want us to answer on the podcast? Submit your questions at https://www.speakpipe.com/hvacschool. Purchase your tickets or learn more about the 6th Annual HVACR Training Symposium at https://hvacrschool.com/symposium. Subscribe to our podcast on your iPhone or Android. Subscribe to our YouTube channel. Check out our handy calculators here or on the HVAC School Mobile App for Apple and Android.